# sstp-client > RouterOS directory reference for /interface/sstp-client. ----------- ## interface/sstp-client **Type:** Directory Whether an item is disabled. Whether the interface is running. Whether hardware encryption is active. Descriptive name of the interface. Maximum Transmission Unit. Maximum Receive Unit. Maximum packet size that can be received on the link. If a packet is bigger than tunnel MTU, it is split into multiple packets, allowing full-size IP or Ethernet packets to be sent over the tunnel. Remote address of the SSTP server. Port to connect to. Proxy address. Proxy port. Client certificate from the certificate store. Verifies the server certificate against the router's certificate store. Verifies the server address from the certificate. User name used for authentication. Password used for authentication. Specifies which PPP profile configuration is used when establishing the tunnel. Keepalive timeout in seconds. Whether to add the SSTP remote address as a default route. Distance value applied to the auto-created default route when add-default-route is enabled. Connects only when outbound traffic is generated. If enabled, a route with a gateway address from 10.112.112.0/24 network is added while the connection is not established. Allowed authentication methods. By default all methods are allowed. Specifies which TLS authentication to use. `yes` - TLS uses ECDHE-RSA and DHE-RSA. `required` - uses only ECDHE. Specifies which TLS version to allow. Allowed ciphers. Adds TLS SNI extension to client hello packets. Available from RouterOS version 7.15.